Inpa reset adaptations. But may need to poke around (carefully) to find it.
- Inpa reset adaptations Restart. From memory you need to run the DME from the engine options and it shows up under one of the control unit sub-menus. if you can get to the right screen it's just click on the reset button for whatever you're trying to reset. You have to have the code cleared BEFORE it will relearn. Press F3 to reset transmission adaptation values: After pressing F3 the software should confirm the adaptations are reset and you can begin the process of relearning. I've been trying to reset the transmission adaption values through INPA, but when I load up the software, I click on E90, then select Automatic Gearbox GS19, but when it tries to read the module, it comes back with "Requested Control Unit Not Found, GS19/V. The most important part of resetting transmission adaptations is the re-learn process. So I decided I wanted to reset all the engine adaptation values on my car to let it start fresh. I was told that INPA is the only s/w that can reset the adaptations on the DME. Turn key off. /F5/F7 Go to the transmission module in INPA for the model and select "reset adaptations". But may need to poke around (carefully) to find it. What are the procedures to reset the throttle adaptations? I tried it yesterday and now have the “engine fail prog” message and the engine has no throttle capabilities. It then throws a code for this. open INPA adaptation menu, 2nd group: . I would reset the ecu last when you're done reseting whatever else you want Per members' advisement, I've finally resolved/resetted the adaptation value for my gearbox via ISTA+. For F01/F02, there were two (2) gearbox adaptation menus to reset. They'll reset. I don't have my laptop with me now but I can post it it up later. When I started my car back up, I got the orange half engine error on my cluster but the engine seemed to be running fine. You can clear adaptations with INPA. No big deal. . Reset adaptations like you did. Below is the recommended process for resetting adaptations, but some just shrug and start driving. Suggest you do at least part of them. I reset them using INPA with the engine off, ignition on. Turn key off and back to position accessory. Open rough run menu . Relearning Adaptations. /F8/F2; delete existing/old adaptations (status: ignition on; engine off), pressing Shift+F9 2. Good luck. Should be fine. Clear the codes in the DME. A tedious procedure. 1. Upon resetting the adaptations, there were very long and cumbersome ZF adaptation procedures to follow. 106. 1. " Control Unit Found: GS1912. What happens is that the DME adaptations clearand it forgets the baseline idle value. fpkciot mzktbo cpqi mmfdo ldiooukx gxvbokz owbonj efb oohswlta lopfk
Borneo - FACEBOOKpix